PIC32-PINGUINO-MICRO  

PIC32-PINGUINO-MICRO - Open Source Hardware Board
PIC32-PINGUINO-MICRO - Open Source Hardware Board PIC32-PINGUINO-MICRO - Open Source Hardware Board PIC32-PINGUINO-MICRO - Open Source Hardware Board
Open Source Hardware Low cost 32 bit PINGUINO MAPLE ARDUINO like development board
Price12.95 EUR
10 - 49 pcs11.66 EUR
50 - 10000 pcs10.36 EUR
In stock

ARDUINO like board with PIC32MX440F256H with USB OTG

FEATURES

  • PIC32MX440F256H 80 Mhz microcontroller 256KB Flash 32KB RAM
  • MicroSD card for data logging
  • UEXT connector which allows many existing modules like RF, ZIGBEE, GSM, GPS to be connected
  • Two LEDs
  • One BUTTON
  • RESET button
  • A Mini USB connector is used, which is common and used in most cell phones, so you do not have to buy other cables
  • All PIC ports available on 0.1" connectors
  • miniICSP connector 0.05"step. If you do not want to use Pinguino IDE and you want to program this board with a PIC-ICD2-POCKET or PIC-KIT3, you should use also a PIC-ICSP converter board, the same applies for Microchip programmers.

SOFTWARE


WARNING

Do not use the "programmer-to-go" button when there is no image on the OLIMEX PIC-KIT3 or MICROCHIP PIC-KIT3 because that might put your microcontroller in an irrecoverable state. We have tested the mentioned scenario and we can confirm it destroys PIC32 chips (using both our and the original Microchip PICKIT3). We don't take responsibility if you break your chip that way. For more info check the following: www.microchip.com/forums/m635420.aspx.