Difference between revisions of "A10s-OLinuXino-MICRO"

(Software)
(Documents)
Line 1: Line 1:
  
 
== Documents ==
 
== Documents ==
 +
User's manual: https://www.olimex.com/Products/OLinuXino/A10S/_resources/A10s-OLinuXino-Micro.pdf
  
 
How to build Linux for A10s from scratch: http://olimex.wordpress.com/2013/06/19/building-linux-for-a10s-from-scratch/
 
How to build Linux for A10s from scratch: http://olimex.wordpress.com/2013/06/19/building-linux-for-a10s-from-scratch/

Revision as of 01:17, 25 July 2013

Documents

User's manual: https://www.olimex.com/Products/OLinuXino/A10S/_resources/A10s-OLinuXino-Micro.pdf

How to build Linux for A10s from scratch: http://olimex.wordpress.com/2013/06/19/building-linux-for-a10s-from-scratch/

Hardware

Under construction

Software

The image in the Nand flash can be updated using the tools found at the following links:

LiveSuit official page

LiveSuit for Windows


A10S-Android is what we ship on 4GB Speed Class10 micro SD card:

A10S Android on 4GB SD-card image Touchscreen, GPIO, HDMI, WIFI support Release-1


A10S-Debian is what we ship on 4GB Speed Class10 micro SD card:

A10S Debian on 4GB SD-card image GPIO, HDMI, WIFI, LAN, USB, LCD support


A10S-Android NAND image we load on A10S-OLinuXino-MICRO-4GB:

A10S Android image for NAND flash


A10S Android 4.2.2 SDK used to generate the Android image

A10S-SDK


Projects

Under construction

FAQ

Q: How to download new Android image to the NAND memory of my A10s board?

A: To repair the image on the NAND re-upload it following these steps:

1. Download, install and start LiveSuit (download location might be found above the article)

2. Hold down “BOOT/REC” button on the board

3. Connect the board to the computer via the mini connector of the USB-OTG

5. Release “BOOT/REC” button

6. You will be asked for drivers for the bootloader. Navigate to the folder where you extracted the LiveSuit and install the drivers from the respective executables (or manually point the installer to the drivers folder in the LiveSuit installation path).

7. Choose the image you have prepared or downloaded

8. Update and don't disconnect the board until the LiveSuit program confirms the update is complete