Welcome, Guest

Author Topic: (small) error in user's manual for Olinuxino-micro  (Read 2741 times)

flavigny

  • Jr. Member
  • **
  • Posts: 52
  • Karma: +0/-0
(small) error in user's manual for Olinuxino-micro
« on: October 01, 2012, 10:41:09 AM »
Hello,
in section 6.4
I read: "The GPIO pins  are led out on a separate 40 pin connector"
il is bviously a sentence related to -maxi board.
regards.
PO.

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1984
  • Karma: +50/-3
Re: (small) error in user's manual for Olinuxino-micro
« Reply #1 on: October 01, 2012, 03:43:53 PM »
Thanks for the feedback, this is now fixed.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex

Kean

  • Jr. Member
  • **
  • Posts: 91
  • Karma: +3/-0
Re: (small) error in user's manual for Olinuxino-micro
« Reply #2 on: October 01, 2012, 05:38:31 PM »
Also note on page 31 in the GPIO pinout, pin 29 of CON1 is listed as "3.3V_E" but is actually GND.

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1984
  • Karma: +50/-3
Re: (small) error in user's manual for Olinuxino-micro
« Reply #3 on: October 04, 2012, 03:17:26 PM »
Thank you, Kean

The table is now fixed. Pin 29 of CON1 is indeed GND.

Regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex