Print Page - (small) error in user's manual for Olinuxino-micro

Title: (small) error in user's manual for Olinuxino-micro
Post by: flavigny on October 01, 2012, 10:41:09 AM

Hello,
in section 6.4
I read: "The GPIO pins are led out on a separate 40 pin connector"
il is bviously a sentence related to -maxi board.
regards.
PO.

Title: Re: (small) error in user's manual for Olinuxino-micro
Post by: LubOlimex on October 01, 2012, 03:43:53 PM

Thanks for the feedback, this is now fixed.

Best regards,
Lub/OLIMEX

Title: Re: (small) error in user's manual for Olinuxino-micro
Post by: Kean on October 01, 2012, 05:38:31 PM

Also note on page 31 in the GPIO pinout, pin 29 of CON1 is listed as "3.3V_E" but is actually GND.

Title: Re: (small) error in user's manual for Olinuxino-micro
Post by: LubOlimex on October 04, 2012, 03:17:26 PM

Thank you, Kean

The table is now fixed. Pin 29 of CON1 is indeed GND.

Regards,
Lub/OLIMEX

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => iMX233 => Topic started by: flavigny on October 01, 2012, 10:41:09 AM