(small) error in user's manual for Olinuxino-micro

Started by flavigny, October 01, 2012, 10:41:09 AM

Previous topic - Next topic

flavigny

Hello,
in section 6.4
I read: "The GPIO pins  are led out on a separate 40 pin connector"
il is bviously a sentence related to -maxi board.
regards.
PO.

LubOlimex

Thanks for the feedback, this is now fixed.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex

Kean

Also note on page 31 in the GPIO pinout, pin 29 of CON1 is listed as "3.3V_E" but is actually GND.

LubOlimex

Thank you, Kean

The table is now fixed. Pin 29 of CON1 is indeed GND.

Regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex