Welcome, Guest

Author Topic: Changing LCD IO Voltage  (Read 1800 times)

solcer

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Changing LCD IO Voltage
« on: August 02, 2016, 10:22:17 PM »
Hello,


I have RK3188-SOM 4G board. Its IO voltage is 3.3V. I want to connect rgb lcd which has 1.8V io voltage to its lcd port. Is there any way to do this with software without making any electronic circuit?

Best,

Selim.

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1811
  • Karma: +46/-2
Re: Changing LCD IO Voltage
« Reply #1 on: August 23, 2016, 09:45:35 AM »
Hello Selim,

Thank you for the e-mail!

I inspected the schematic and the possibilities and unfortunately there is no 1.8V option provided. You would need to drive down the signals to 1.8 externally.

Alternatively, you can also use one of our compatible LCDs which are easy to get installed with default image in the RK3188-SOM board, for example:

- LCD-OLinuXino-7: https://www.olimex.com/Products/OLinuXino/LCD/LCD-OLinuXino-7/open-source-hardware
- LCD-OLinuXino-10: https://www.olimex.com/Products/OLinuXino/LCD/LCD-OLinuXino-10/open-source-hardware

We also have bigger displays and also resistive touchscreens. Make sure to check the whole sub-category “LCD”: https://www.olimex.com/Products/OLinuXino/LCD/

The the wiki article of the board described how to enable the support for 4.3", 7" and 10" displays. The wiki article is available here: https://www.olimex.com/wiki/RK3188-SOM

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex