Olimex MSP430 Programmer not working on SpyBiWire on CC430 MCU

Started by alanchansl, May 16, 2013, 01:12:06 PM

Previous topic - Next topic


I have a OLIMEX MSP430-CCRFLCD EVB and installed OLIMEX_MSP430_PROGRAMMER_GUI_1.3.0.4_CLI_2.0.1.2_DLL_1.0.4.2.zip with the driver OLIMEX-MSP430-DLL-drivers-1.042.zip. I also has the JTAG MSP430-JTAG-TINY-V2. When I using the programer with SpyBiWire option checked, it cannot identify the device. If I using the full JTAG connection, it is no problem. Can any help me to solve my problem? Thank you very much.


I also tried to replace the dll files from OLIMEX MSP430-DLL drivers 2.007. It is also not working  :-[


Hey alanchansl,

This is strange. It works fine with SBW here. I used version of drivers.

I also added the new device at the end of the "olidev.ini" in the Olimex MSP programmers software folder as:

:CC430F5137 00008000 0000ffff 00001800 000019ff

And then selected CC430F5137 from the drop-down menu.

My successful read is shown here: http://i.imgur.com/4z0LwlQ.png

P.S. Try disabling the calibration area; additionally check if the board is properly power and if powering from the JTAG then PIN jumper should be closed, POUT open.

Best regards,
Technical support and documentation manager at Olimex


Hi Lub/Olimex,

Thank you for your response.
I followed your advice, I am still not able to use the SBW and it display the dialog box "Cannot identify target device!"

When I use MSP-FET430UIF, it can detect the device without problem.
Any others advice for me?



Technical support and documentation manager at Olimex