Welcome, Guest

Author Topic: Olimex PIC32HMZ144  (Read 707 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Olimex PIC32HMZ144
« on: October 31, 2017, 07:10:21 PM »
Hi all.
Received target Board,I wanted to know if the bootloader is flashed to the processor.
Or need to buy PicKit3.
Thank you.


  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1819
  • Karma: +46/-2
Re: Olimex PIC32HMZ144
« Reply #1 on: November 01, 2017, 09:16:58 AM »

Congrats on your new board! PIC32-HMZ144 is a general-purpose development board. You need an ICSP programmer (or emulator or debugger). Notice that the on-board ICSP interface is available at a 6-pin (1×6) 0.1” step connector. If your programmer has another type of connector you might need an adapter like PIC-ICSP or similar.

This is also mentioned in chapter "1.2 MINIMAL BOARD USE REQUIREMENTS" in the user's manual here: https://www.olimex.com/Products/PIC/Development/PIC32-HMZ144/resources/PIC32-HMZ144_UM.pdf

Best regards,
Technical support and documentation manager at Olimex