Hi all.
Received target Board,I wanted to know if the bootloader is flashed to the processor.
Or need to buy PicKit3.
Thank you.
Hey,
Congrats on your new board! PIC32-HMZ144 is a general-purpose development board. You need an ICSP programmer (or emulator or debugger). Notice that the on-board ICSP interface is available at a 6-pin (1×6) 0.1" step connector. If your programmer has another type of connector you might need an adapter like PIC-ICSP or similar.
This is also mentioned in chapter "1.2 MINIMAL BOARD USE REQUIREMENTS" in the user's manual here: https://www.olimex.com/Products/PIC/Development/PIC32-HMZ144/resources/PIC32-HMZ144_UM.pdf
Best regards,
Lub/OLIMEX