Welcome, Guest

Author Topic: the OlinuXino A13 BOM?  (Read 1039 times)

figoarzaki

  • Newbie
  • *
  • Posts: 22
  • Karma: +0/-0
the OlinuXino A13 BOM?
« on: June 02, 2017, 09:42:26 AM »
Hello there.
where i can find OlinuXino A13 board Bill of material?,
i did'nt find any in olimex github repositories

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1713
  • Karma: +43/-2
Re: the OlinuXino A13 BOM?
« Reply #1 on: June 02, 2017, 03:21:04 PM »
Each component is listed in the schematic and board files. When you open the sources in eagle, type in the bar "run BOM" or use the export menu.
Technical support and documentation manager at Olimex

figoarzaki

  • Newbie
  • *
  • Posts: 22
  • Karma: +0/-0
Re: the OlinuXino A13 BOM?
« Reply #2 on: June 02, 2017, 06:07:52 PM »
thanks!

but can i know what is actually NA value capacitor/resistor?

like this
2   NA  CPOL-EUE3.5-8   E3,5-8   C142, C143

4   NA R-EU_R0603_5MIL_DWS  R0603_5MIL_DWS    R3, R42, R44, R95

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1713
  • Karma: +43/-2
Re: the OlinuXino A13 BOM?
« Reply #3 on: June 05, 2017, 10:36:33 AM »
NA means "Not Assembled". The component is not placed at all by design.

Some components are not placed and their pads are provided usually as an option for the customers (if you decide you need a component there). It depends on each occurrence of such component. Some are not placed since they are redundant, some are not placed since they change the behavior of this part of the design, etc.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex