EKG/EMG shield ElecGuru bad trace with noise

Started by ipav, April 26, 2016, 11:20:40 pm

Previous topic - Next topic

ipav

I get no real trace in ElectricGuru software, only a lots of lines that goes up and down.

What can one do to get a real noise free trace reading?

Is there any adjustments in the ElecGuru software that needs to be done or any adjustments on the shield itself ? What about the Gain adjustment on the shield?

Thanks in advance.

joe50

Hi Ipav,

Late to the party, but check out this thread: https://www.olimex.com/forum/index.php?topic=936.0

I hope you found a solution in the meantime