Print Page - EKG/EMG shield ElecGuru bad trace with noise

Title: EKG/EMG shield ElecGuru bad trace with noise
Post by: ipav on April 26, 2016, 11:20:40 PM

I get no real trace in ElectricGuru software, only a lots of lines that goes up and down.

What can one do to get a real noise free trace reading?

Is there any adjustments in the ElecGuru software that needs to be done or any adjustments on the shield itself ? What about the Gain adjustment on the shield?

Thanks in advance.

Title: Re: EKG/EMG shield ElecGuru bad trace with noise
Post by: joe50 on December 02, 2016, 11:18:03 AM

Hi Ipav,

Late to the party, but check out this thread: https://www.olimex.com/forum/index.php?topic=936.0

I hope you found a solution in the meantime

Olimex Support Forum

DUINO => SHIELDS => Topic started by: ipav on April 26, 2016, 11:20:40 PM