Shield data to Arduino

Started by fookea, May 20, 2015, 06:00:16 pm

Previous topic - Next topic



I recently purchased a EMG-EKG shield from you guys after struggling with a TI dev kit. I am now in the process of figuring out how data is extracted from the shield. I only need to feed the data to a virtual serial port so i can process it in Matlab.

Basically all I need to do is get the data and Serial.print it.

I am kinda running out of time ( only 1 month left till the deadline ) so this is why i don't really have time to figure out stuff on my own...sorry if this has been already discussed.

Can anybody help me with the info necessary?
Thanks in advance!


Stupid me,I figured it out :-)

One more question:
Is the sampling rate of the signal set by the sampling rate of the serial com?


The sampling rate is 256 Hz.