Olimex Support Forum

Others => Biofeedback - EEG, ECG, EKG => Topic started by: fookea on May 20, 2015, 06:00:16 PM

Title: Shield data to Arduino
Post by: fookea on May 20, 2015, 06:00:16 PM
Hello,

I recently purchased a EMG-EKG shield from you guys after struggling with a TI dev kit. I am now in the process of figuring out how data is extracted from the shield. I only need to feed the data to a virtual serial port so i can process it in Matlab.

Basically all I need to do is get the data and Serial.print it.

I am kinda running out of time ( only 1 month left till the deadline ) so this is why i don't really have time to figure out stuff on my own...sorry if this has been already discussed.

Can anybody help me with the info necessary?
Thanks in advance!
Title: Re: Shield data to Arduino
Post by: fookea on May 20, 2015, 07:02:20 PM
Stupid me,I figured it out :-)

One more question:
Is the sampling rate of the signal set by the sampling rate of the serial com?
Title: Re: Shield data to Arduino
Post by: Badreddinez on June 20, 2015, 04:47:45 PM
The sampling rate is 256 Hz.