Welcome, Guest

Author Topic: A10S MICRO how to connect  (Read 2858 times)

lukasik

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
A10S MICRO how to connect
« on: May 12, 2015, 05:54:31 PM »
Hello,

I'm begginer with this so this is maybe trivial but I'm stuck.

My setup:
  • A10S-OLinuXino-MICRO Rev.C
  • UART to notebook USB, see images: http://1drv.ms/1csXOva, http://1drv.ms/1RzR5A3
  • MicroUSB connected to notebook USB
  • LAN to router
  • SD card with A10S_debian_3_4_GPIO_LAN_USBs_SDs_HDMI_LCD_I2C_100KHz_TS_4G_release_4.img created by dd bs=4M oflag=sync if=A10S_debian_3_4_GPIO_LAN_USBs_SDs_HDMI_LCD_I2C_100KHz_TS_4G_release_4.img
  • screen /dev/ttyUSB0 115200

If I connect device to pc pwr led light is on but nothing else happens, no dhcp client in router/data on tty
Hold ~8 power - goes off
Hold ~1s power - goes to the same state as before

How do I get this to work?



JohnS

  • Hero Member
  • *****
  • Posts: 1709
  • Karma: +33/-45
Re: A10S MICRO how to connect
« Reply #1 on: May 25, 2015, 11:24:15 AM »
With dd, what of= ?

Onedrive just says Sorry, something went wrong.  You need only GND, Tx, Rx connected at A10S.  If no output, swap Tx & Rx.

John