MSP430 not being recognized by Smart RF when using MSP-FET

Started by renanpontara, July 29, 2014, 12:18:49 pm

Previous topic - Next topic

renanpontara

Hello everyone,

I am trying to use the Smart RF Software on my cc430f5137 EVM board but the connector that I have is the New MSP-FET from TI and for some reason the Smart RF is not able to recognize the device. The software for the board is up to date.
Is this new FET connector not supported by the Smart RF tool?
I was thinking about getting the CC Debugger to fix it, but I am not sure if is going to solve the problem. Any advices?
Thanks a lot,

Renan.