Welcome, Guest

Author Topic: Using MOD-POE V2 on PIC boards  (Read 1343 times)

kayjay

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Using MOD-POE V2 on PIC boards
« on: February 04, 2014, 01:50:54 PM »
Has anyone tried using these boards on PIC (non POE) dev boards? Without connecting any load - if I connect the input to a POE switch all works well but if I connect the input to a POE injector (@48V) the board dies instantly never to work again. Has anyone ever tried this. Olimex - is this a fault? Should I expect this to work?

Many thanks