Olimex Support Forum

Microcontrollers => PIC => Topic started by: kayjay on February 04, 2014, 01:50:54 PM

Title: Using MOD-POE V2 on PIC boards
Post by: kayjay on February 04, 2014, 01:50:54 PM
Has anyone tried using these boards on PIC (non POE) dev boards? Without connecting any load - if I connect the input to a POE switch all works well but if I connect the input to a POE injector (@48V) the board dies instantly never to work again. Has anyone ever tried this. Olimex - is this a fault? Should I expect this to work?

Many thanks