September 25, 2020, 10:49:55 pm


Started by kik0, June 14, 2013, 03:18:30 pm

Previous topic - Next topic


Sorry this question may be stuped but, I bought

and my question is - can i program this board whit

I have never programmed a microcontroller so I'm not sure that is going to work


Hey kik0,

This would depend very much on your operating system. Generally PIC-PG1 works fine with older computers (that still have a free COM/RS232)and Windows XP or Linux. PIC-PG1, however, doesn't work with MPLAB natively - you would have to write the code, then compile a binary, then upload the binary through another program. You will also be unable to debug in real time. Now if you have to do only once it won't be a problem but if you make 50 changes to the program and each time you want to test it will slow you down a lot.

If you are a beginner I recommend you to get a better/more expensive programmer/debugger initially. For example, a good debugger/programmer is: - it works with older and newer MPLABs fine, and MPLAB is a well-documented and widely used software IDE. It is also free.

Best regards,
Technical support and documentation manager at Olimex