Any suggestion?

[Beatento]

Hi all,

My LIME2 board is working fine with A20-OLinuXino-bullseye-base image if I connect it through HDMI, but 7" and 4.3" olimex LCDs are not working at all. No video, no light.

I'm using the 0.5 pitch 40 pin cable, and power up the LIME2 board with a 5V 2A power source.

Any suggestion? Thanks!

[LubOlimex]

You need to run the video output script inside the image. After login run:

olinuxino-display

then enable the specific display. Reboot.

Be very careful about the connectors and the orientation. Track pin #1. Pin #1 from the LCD should go to pin #1 from the board LCD_CON connector.