November 08, 2024, 07:06:10 AM

ESP32-PoE-ISO SSH1106

Started by vestbjerg48, January 13, 2020, 06:35:11 PM

Previous topic - Next topic

vestbjerg48

Im trying to get a SSH1106 display running on I2C with the PoE ISO board.

I have it working with IDF 4 on a plain ESP32 WROOM, but with the PoE ISO board, the ethernet fails when the display is initialised.

The display is detected on the i2c bus.

   
#define MYSDA_PIN 3
#define MYSCL_PIN 4


    0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f
00:          -- -- -- -- -- -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- 3c -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
70: -- -- -- -- -- -- -- --


conf.mode = I2C_MODE_MASTER;
    conf.sda_io_num = MYSDA_PIN;
    conf.scl_io_num = MYSCL_PIN;
    conf.sda_pullup_en = GPIO_PULLUP_ENABLE;
    conf.scl_pullup_en = GPIO_PULLUP_ENABLE;
    conf.master.clk_speed = 100000;
    i2c_param_config(I2C_NUM_0, &conf);

    i2c_driver_install(I2C_NUM_0, I2C_MODE_MASTER, 0, 0, 0);

ESP_LOGI(TAG, "Starting display");
      sh1106_128x64_i2c_init();
      ssd1306_fillScreen(0x00);
      ssd1306_setFixedFont(ssd1306xled_font5x7 );

The green and amber leds are on for a couple of seconds, and then they go off for a couple of seconds.

vestbjerg48

False alarm. It was an error 40. The library for the display was using fixed SDA and SCL pins, and once i overruled those, the display worked fine.