Using the olimex ecg sensor with other platforms

Started by fenesoguz, July 11, 2019, 10:52:30 AM

Previous topic - Next topic


hi, i would like to use the olimex ecg sensor with esp32 Wroom.

I didn't get value from the sensor's analog pins, Is it only works with this sensor arduino or How should I do a pin connection?
I'm waiting for your help


Hardware-wise SHIELD-EKG-EMG should work with ESP32 without much issues. The ESP32 design has ADC pins that work up to 3.3V. SHIELD-EKG-EMG is set by default to 3.3V operation and the analog outputs are also at 3.3V. Some software adjustment would be required, of course. Connection and software suggestions can be seen in this tutorial:

Best regards,
Technical support and documentation manager at Olimex