ESP32-POE-ISO not responding to ARP Req

Started by alborz, June 13, 2019, 09:24:03 am

Previous topic - Next topic

alborz

Hi,

I am running the simple Ethernet test example for Arduino and it seems to work fine. I am seeing the following:
ETH Started
ETH MAC: 30:AE:A4:9F:F7:A7, IPv4: 192.168.0.61, FULL_DUPLEX, 100Mbps
ETH MAC: 30:AE:A4:9F:F7:A7, IPv4: 192.168.0.61, FULL_DUPLEX, 100Mbps


But my question is why I am not seeing any response from the board when I am sending out ARP request. Is ETH.begin() enough to have everything upp and running, or am I missing something?

(I have some wifi connected esp32 and I can see them sending out ARP responses just fine)

alborz

Can not delete this topic, but the problem was on my side. The router was the problem