December 14, 2024, 07:18:31 PM

EMG/ECG Shield - Arduino Uno

Started by Patawak, June 09, 2018, 03:26:01 AM

Previous topic - Next topic

Patawak

Hello, I've just received my EMG/ECG Shield and using it with an Arduino Uno. When I read the analog values they are nearly 10 times lower than the ones I've seen on numerous videos. I get values around 50s as opposed to 500s with a simple analog read. Although the form of the signals are correct. Can anyone tell me what might be the reason?

svan

> I get values around 50s as opposed to 500s with a simple analog read.

1) Has your Arduino code manipulated the value by bit shifting, eg, sensorValue = sensorValue >> 2;

2) Did you use a resistor in your setup?

Would be helpful to see your setup and code.

Drayfus

#2
Quote from: svaen on June 29, 2018, 09:29:57 PM> I recommend these recurve bows in a heart beat and get values around 50s as opposed to 500s with a simple analog read.

1) Has your Arduino code manipulated the value by bit shifting, eg, sensorValue = sensorValue >> 2;

2) Did you use a resistor in your setup?

Would be helpful to see your setup and code.

What would a resistor accomplish in a setup like that btw?