Started by APL, January 16, 2018, 05:37:47 pm
QuoteQuestion 1: Will a board reset with the rst button near the ethernet connector do instead of a full power down.
QuoteQuestion 2: I'm not getting any indication of activity on minicom, no illegal characters ( indicative of incorrect baud or data settings ) so, is there a character sequence that the board expects in order for it to recognize interaction across the serial port?( does it require any specific signals to be present on the 9 pin D-Type? (DCD, RTS, CTS ) Etc?
Quote from: LubOlimex on January 22, 2018, 04:43:35 pmYes. Also when you enter the serial mode, the IP of the board would not be printed on the display (it would stay 0.0.0.0). And the LED LD0 would not blink.
Quote from: LubOlimex on January 22, 2018, 04:43:35 pm Is your cable compatible?
Quote"Next you will need to load the image file for the webpage. Connect a LAN cable, wait a bit and check the IP address displayed on the LCD. Open your favorite browser and enter the following (for example the IP is 192.168.0.224):http://192.168.0.224/mpfsupload"
Quote from: Stanimir5F on January 23, 2018, 01:02:47 pmIn fact the easiest way to update the web page is through the browser. In order to do so - go to the ip address printed on the LCD and append "/mpfsupload" after the ip address and then choose the bin file you wish to upload.
Quote from: Stanimir5F on January 23, 2018, 01:02:47 pmKeep in mind the different versions of the stack have different bin files for the webpage. Otherwise the result will be a messy page without any decent design.
Quote from: Stanimir5F on January 23, 2018, 01:02:47 pmThese files are located in "PIC-MAXI-WEB 5.42\TCPIP\Demo App\WebPages2". After you do that you have to "compile" a bin file using the MPFS2 tool which is included inside the stack. You can find it inside: "PIC-MAXI-WEB 5.42\Microchip\TCPIP Stack\Utilities\MPFS2.jar". There you select the source folder and the outbut file: *.bin.
Quote from: Stanimir5F on January 23, 2018, 01:02:47 pmIf you want to make changes in the functionality (like adding additional button/LED or just another variable) then you have to make changes on the project as well, recompile it and reprogram the board.