Welcome, Guest

Author Topic: LPC1778 - ARM-USB-OCD-H - Eclipse - debug error  (Read 1848 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
LPC1778 - ARM-USB-OCD-H - Eclipse - debug error
« on: February 10, 2017, 07:26:16 PM »
Hi all,
I need to program a LPC1778 micro by the Olimex ARM-USB-OCD-H adaptor.
I set up the Eclipse to compile and run the firmware but when I launch it I receive the following messages:

GNU ARM Eclipse 64-bits Open On-Chip Debugger 0.10.0-00113-g0f83948 (2017-01-24-18:48)
Licensed under GNU GPL v2
For bug reports, read
Info : auto-selecting first available session transport "jtag". To override use 'transport select <transport>'.
adapter speed: 10 kHz
adapter_nsrst_delay: 200
jtag_ntrst_delay: 200
cortex_m reset_config sysresetreq
Started by GNU ARM Eclipse
Error: libusb_open() failed with LIBUSB_ERROR_NOT_SUPPORTED
Info : clock speed 10 kHz
Info : JTAG tap: lpc17xx.cpu tap/device found: 0x4ba00477 (mfg: 0x23b (ARM Ltd.), part: 0xba00, ver: 0x4)
Info : lpc17xx.cpu: hardware has 6 breakpoints, 4 watchpoints
Info : accepting 'gdb' connection on tcp/3333
Error: Target not halted
Error: auto_probe failed
Error: Connect failed. Consider setting up a gdb-attach event for the target to prepare target for GDB connect, or use 'gdb_memory_map disable'.
Error: attempted 'gdb' connection rejected

Any idea?


  • Hero Member
  • *****
  • Posts: 1709
  • Karma: +33/-45
Re: LPC1778 - ARM-USB-OCD-H - Eclipse - debug error
« Reply #1 on: February 11, 2017, 12:57:55 PM »
Post on oocd ML with proper info (OS, -d3 etc)