Welcome, Guest

Author Topic: i.MX233 LQFP-128 Debug UART and 8 bit (4:2:2) RGB TFT LCD  (Read 1046 times)

rohitabho

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
i.MX233 LQFP-128 Debug UART and 8 bit (4:2:2) RGB TFT LCD
« on: May 07, 2017, 05:02:19 AM »
I am designing custom board based on i.MX233 LQFP-128 but I need two UART for my application. This package have one application UART and one Debug UART. Is it possible to use Debug UART for external device communication like GSM/GPS Module? Is it possible to achieve baudrate 115200 for Debug UART?

I need to use LCDIF to interface 24 bit parallel RGB TFT LCD in 8 bit (4:2:2) mode. Is it possible with linux freambuffer?

Thank you!

lambda

  • Full Member
  • ***
  • Posts: 152
  • Karma: +11/-0
    • Support my work
Re: i.MX233 LQFP-128 Debug UART and 8 bit (4:2:2) RGB TFT LCD
« Reply #1 on: May 08, 2017, 11:05:29 PM »
About the baudrate 115200 is the default on olinuxino boards, so yes this should work.

About using the Debug UART: Linux can direct the system console somewhere else, then the UART is free for other uses. However it might miss RTS/CTS handling. Not sure, you have to look it up, if you need this.