Welcome, Guest

Author Topic: U-boot - need a different storage medium- EVB  (Read 1548 times)

pradeepsysargus

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
U-boot - need a different storage medium- EVB
« on: July 10, 2016, 02:14:14 PM »
For RT5350F-OlinuXino- EVB,
 I know that it is using SPI NAND flash to boot from initially. I think the initial u-boot is also located in SPI NAND/NOR flash.


In a board we are designing, we have a different flash, mostly a NOR Flash. We are designing this board taking EVB as reference design.
I donot know how to load the u-boot to this new NOR flash with a new part number.
We have SD-Card slot and an MMC card slot on the board.
Is there a way I can program a SD card or MMC card with u-boot firmware? How do I make sure that this u-boot recognizes the same SDRAM(256Mbit size) that is on our board ?

Thanks,

Syd

  • Newbie
  • *
  • Posts: 15
  • Karma: +1/-0
Re: U-boot - need a different storage medium- EVB
« Reply #1 on: August 23, 2016, 06:38:16 PM »
I think you need write
- Put "uboot" bootloader on SD card with tools programme( dd , board .. etc).
- In OpenWRT, may be change rt5350.dts and OLINUXINO-RT5350F.dts for SPI partition & pin for SD detection.

and lot of caffee  ... --'