msp430-PIR(msp430f2013) debug and download error problem in IAR

Started by rnavodaya, May 05, 2015, 01:54:46 PM

Previous topic - Next topic

rnavodaya

hi,
After debugging, I tried to download the code to msp430-PIR(msp430f2013)but it showing below errors

I'm using MSP-FET430UIF debugger.....

Using license: Evaluation license - IAR Embedded Workbench for Texas Instruments MSP430, Evaluation Version 6.30
Firmware version 3.4.3.4
Interface dll version 3.4.3.4
Unknown device : (OpenDevice) , Device=MSP430F20x3, PwLength=0x0
Fatal error: Could not find device (or device not supported)   Session aborted!


LubOlimex

Hey,

By default the board has a different SBW layout on the JTAG connector compared ot the SBW layout. You would need to change the state of two SMT jumpers to get it working with MSP-FET430UIF. The two jumpers are OLI_TEST/TI_TEST and OLI_RES/TI_RES. By default hte board is sold with these jumpers in position OLI_TEST and OLI_RES, you have to cut between the pads of the original connection and then solder the pads of the TI_TEST together and then again solder the pads of TI_RES position together.

I also recommend you to check the schematics here: https://www.olimex.com/Products/MSP430/Starter/MSP430-PIR/resources/MSP430-PIR-sch.gif

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex