Welcome, Guest

Author Topic: PIC32-T795 - programming problems  (Read 2735 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
PIC32-T795 - programming problems
« on: November 27, 2012, 12:08:53 AM »
Hello. I've just bought PIC32-T795 board and i have a strange problem programming it. It's working fine as long as i'm in debug mode. But after i put it in release mode it is not executing program - even simple led blinking  :( I've been working on few different PIC32 processor platforms and i never had such problem before. I'm using MPLAB X and ICD 3 hardware. I've checked the same software on different PIC32 processor board and it works just fine. Any clues??


  • Administrator
  • Hero Member
  • *****
  • Posts: 815
  • Karma: +22/-3
Re: PIC32-T795 - programming problems
« Reply #1 on: November 27, 2012, 08:11:27 AM »
this usually happens when you setup your linker to place your code in RAM
make it to place your code in Flash and try again :)