June 25, 2024, 06:11:25 PM


Started by seanomahony, March 05, 2015, 04:39:24 PM

Previous topic - Next topic



I have recently upgraded from the older MSP430-JTAG-ISO to the MK2 and I'm having difficulties programming any boards. Using both the FET-Pro 430 software and IAR IDE, I receive errors every time. The IAR error reads device not found and the FET-Pro 430 error is JTAG failed to initialize. I have installed the newer drivers and probed the JTAG adapter for faults but can see nothing wrong. Previously there had been no issues in using the earlier version of the programmer.

I have also tried upgrading and downgrading the firmware on the programmer to no avail.

Any help or thoughts would be greatly appreciated