OLIMEXINO-5510

Started by randy, November 15, 2012, 02:45:20 pm

Previous topic - Next topic

randy

How can I download the IAR examples into the board? Is it necessary to by additional
hardware or is it posible with the existing usb connection on the board?

maria_olimex

Hello randy

There are two ways to download code to the msp430 chip:
1) Compile your binary with IAR EW(or other tool) and use a USB connection and the USB firmware updater tool provided by TI:
http://www.ti.com/tool/msp430usbdevpack

2) Using a separate programmer - this will allow you to upload/debug your code with IAR. Take a look at two of our programmers:
https://www.olimex.com/Products/MSP430/JTAG/MSP430-JTAG-TINY-V2/
https://www.olimex.com/Products/MSP430/JTAG/MSP430-JTAG-ISO-MK2/

Best Regards,
Maria/OLIMEX
Software developer at Olimex
Olimex ODS Project
Introduction to Olimex ODS