Welcome, Guest

Author Topic: EEG-SMT: Using 1 Channel only?  (Read 4025 times)

Axel

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
EEG-SMT: Using 1 Channel only?
« on: November 12, 2012, 08:37:14 AM »
Hi,

I want to use 1 Channel only. Circuit diagram says, I should connect the unused channel inputs to V_REF. But, it is not easy to do this, is it?

Is it fine to connect to GND (ground, outer pin of plug), instead?

Best regards,
Axel

Kris

  • Newbie
  • *
  • Posts: 9
  • Karma: +0/-0
Re: EEG-SMT: Using 1 Channel only?
« Reply #1 on: November 12, 2012, 10:58:54 PM »
Hi,

I want to use 1 Channel only. Circuit diagram says, I should connect the unused channel inputs to V_REF. But, it is not easy to do this, is it?

Is it fine to connect to GND (ground, outer pin of plug), instead?

Best regards,
Axel

I think you must connect the channel +/- to the drl, you can use a 3.5 splitter like these

http://www.amazon.com/3-5mm-Stereo-Female-Male-Adaptor/dp/B000I21Z4U/ref=sr_1_5?ie=UTF8&qid=1352753890&sr=8-5&keywords=3.5+splitter

Axel

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: EEG-SMT: Using 1 Channel only?
« Reply #2 on: November 13, 2012, 08:03:29 AM »
Hi Kris,

thank you for your advise. The 3.5 splitter is a great idea, I didn't know that such a thing exists!

Axel