Welcome, Guest

Author Topic: Configuring SAM7P256 with ARMUSBOCD  (Read 3019 times)

prateekarora89

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Configuring SAM7P256 with ARMUSBOCD
« on: August 08, 2013, 05:03:47 PM »
HI,


I have Recently purchased an OLIMEX SAM7P256  Board and I want to Configure it using ARM USB OCD.  I have done most of the part but I am facing problem during flash programming the device it is not able to find the script.ocd file so kindly help me out in this.


LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1984
  • Karma: +50/-3
Re: Configuring SAM7P256 with ARMUSBOCD
« Reply #1 on: September 04, 2013, 03:48:30 PM »
Hello prateekarora89,

Have you tried with the free Olimex OpenODS IDE? Might be found here: https://www.olimex.com/Products/ARM/JTAG/_resources/OpenOCD/.

The script needed for SAM7-P256 is typically located in openocd-0.7.0\scripts\target in the OpenOCD folder. It is named "at91sam7x256.cfg".

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex