can a lime 2 or pico 2 xxl run an open printer in a free software manner?

[oeren]

https://www.crowdsupply.com/open-tools/open-printer

In the following I am assuming that the software which is running the open printer is free software.
Unfortunately the open printer people decided to go with a rpi zero w. The rpi zero w requires non free software in order to work. In result free software people do not want to use the open printer. On the other hand should it be possible to replace the rpi zero w with a computer able to run entirely on free software the open printer would get relevant for free software people.
Both lime 2 and pico 2 xxl can run entirely on free software correct? If so can I get to know if the lime 2 and pico 2 xxl are candidates for replacing a rpi zero w?
Please do not provide answers if you are not familiar with what free software is in the context of the free software foundation. Thank you.


 

[LubOlimex]

All three of the boards that you mentioned can run completely open source software. Yet there is major difference between the Raspberry Pi product and Olimex products - Raspberry Pi Zero W is not open-hardware, while Olimex provides files used to manufacture their products, when it comes to A20-OLinuXino-LIME2 and PICO2-XXL. These are open-hardware products.

About the software - the official Linux image provided by Olimex for A20-OLinuXino-LIME2 is truly open-source software, and contains no binary blobs. This is mentioned in the Olimage guide here:

https://github.com/OLIMEX/OLINUXINO/blob/master/DOCUMENTS/OLIMAGE/Olimage-guide.pdf

PICO2-XXL doesn't come with own software, the software Olimex provides for PICO2-XXL is based on the RPi SDK, so expect similar software as what Raspberry Pi Zero W uses.

[Roman]

The rpi zero w requires non free software in order to work.

Quoting from a Stack Exchange answer for context.

The Pi Zero uses the BCM2835 system-on-a-chip, which combines a CPU and a VideoCore 4 GPU ... the GPU bootstraps the CPU and loads a kernel into it ... the firmware required for the GPU is from closed source.

In contrast, A20-OLinuXino-LIME2 does not require any proprietary binary blobs to boot. For example, Guix System, which is compliant with the Free System Distribution Guidelines (FSDG), is known to run on it.

However, A20-OLinuXino-LIME2 is much larger, it is twice as wide as Raspberry Pi Zero W. Would it be possible for Open Printer to fit it in their design?

PICO2-XXL is a "re-design of the popular 'Raspberry Pi Pico 2'", so it does not run GNU/Linux. Could Open Printer still use it?