Olimex Support Forum

Others => Biofeedback - EEG, ECG, EKG => Topic started by: Aa on May 25, 2020, 01:19:43 pm

Title: SHIELD-EKG-EMG output jumper
Post by: Aa on May 25, 2020, 01:19:43 pm
Hi

Re: SHIELD-EKG-EMG

When conecting the SHIELD-EKG-EMG to Arduino, How can I select the Analog output that feed the signal to the Arduino board?

A
Title: Re: SHIELD-EKG-EMG output jumper
Post by: LubOlimex on May 26, 2020, 09:32:48 am
Set AIN_SEL jumper accordingly.
Title: Re: SHIELD-EKG-EMG output jumper
Post by: Aa on May 26, 2020, 10:25:54 pm
Thanks, but the AIN_SEL jumpers number are 1,3,5,7,9 and the analog are A0 - A5.
How can I jumper analog A4, for example, to be the output that feed the signal to the Arduino board? What is the corelation between the AIN_SEL numbers and Analogpin numbers?
Title: Re: SHIELD-EKG-EMG output jumper
Post by: svan on May 27, 2020, 09:35:25 am
>What is the correlation between the AIN_SEL numbers and Analogpin numbers?

A0 = 1,2
A1 = 3,4
A2 = 5,6
A3 = 7,8
A4 = 9,10
A5 = 11,12