Print Page - EMG Data Acquisition Arduino UNO R3 Macbook

Title: EMG Data Acquisition Arduino UNO R3 Macbook
Post by: olidupri on February 24, 2020, 04:22:32 AM

I have the SHIELD-EKG-EMG-PA and i am trying to get readings from the sensors. Using an arduino UNO R3 I get weird symbols rather than actual values when I use the serial monitor in the Arduino IDE. I do not really understand how to interpret the example code. I am only trying to utilize one shield, so should I adjust the NUMCHANNELS variable so that it equates to 1? What would be the best configuration of the headers if I am trying to receive an EMG signal? Do I need the Toggle_LED1 function? Should I expect a processed or raw EMG signal? Which analogue pins are reading data? Is the output actually digital values?

Title: Re: EMG Data Acquisition Arduino UNO R3 Macbook
Post by: LubOlimex on February 24, 2020, 08:41:44 AM

You have SHIELD-EKG-EMG right? Because SHIELD-EKG-EMG-PA is just the passive electrode. You need visualization software or processing of data stream coming from SHIELD-EKG-EMG. "Strange symbols" are expected if you just use serial monitor. Check this old thread: https://www.olimex.com/forum/index.php?topic=5474.0

QuoteWhich analogue pins are reading data?

Depends on the AIN_SEL jumper. Between A0 and A5. Refer to the schematic: https://www.olimex.com/Products/Duino/Shields/SHIELD-EKG-EMG/resources/SHIELD-EKG-EMG-REV-B-SCHEMATIC.pdf

Title: Re: EMG Data Acquisition Arduino UNO R3 Macbook
Post by: olidupri on February 24, 2020, 07:53:59 PM

Thank you for responding quickly. I am using a Mac, so I can't download the electric guru software. Is there any other way I can go about outputting the data?

Title: Re: EMG Data Acquisition Arduino UNO R3 Macbook
Post by: LubOlimex on February 25, 2020, 08:18:32 AM

Use one of the visualization tools for EEG-SMT, they'd work with the SHIELD too. Check these, they might have Mac support:

http://www.shifz.org/brainbay/
http://openvibe.inria.fr/

and also the list here (check the description):

http://openeeg.sourceforge.net/doc/sw/

Also please notice that SHIELD-EKG-EMG is a mature and quite popular product, there are a lot of things published online by customers, there might be something for Mac.

Title: Re: EMG Data Acquisition Arduino UNO R3 Macbook
Post by: svan on May 08, 2020, 10:50:35 PM

>there are a lot of things published online by customers, there might be something for Mac.

This Processing app will run on a Mac (or other operating systems): https://github.com/vsquared/ECG_UNO_Processing3_2_3 (https://github.com/vsquared/ECG_UNO_Processing3_2_3)

It was written for ecg but should work for emg also.

Olimex Support Forum

DUINO => SHIELDS => Topic started by: olidupri on February 24, 2020, 04:22:32 AM