Olimex Support Forum

Hi All!

I'm successfully using Energia.nu v17 [1] with the C2000 LaunchPadXL TMS320F28069M.[2]
This makes getting started with that MCU really easy!!  8)

That LaunchPadXL has the following on board:

• A Texas Instruments TMS320F28069M micro-controller
• XDS100v2 debug probe (with USB connector)

Now, since Energia is working fine with the LaunchPadXL, can I safely assume also
that Energia will work with the following setup?

• A TMS320F28069M dev-board with JTAG. [3]
• The OLIMEX XDS100-V2
  

Can anyone confirm this?  ???
Thanks a lot!!  :)

[1] http://energia.nu/pinmaps/launchxl-f28027f/ (http://energia.nu/pinmaps/launchxl-f28027f/)
[2] http://www.ti.com/tool/LAUNCHXL-F28069M (http://www.ti.com/tool/LAUNCHXL-F28069M)
[3] https://github.com/SDI-SoftwareDefinedInverter/TAPAS/blob/master/TAPAS V1.0 - Schematic.pdf (https://github.com/SDI-SoftwareDefinedInverter/TAPAS/blob/master/TAPAS%20V1.0%20-%20Schematic.pdf)

PS: The TMS320F28069M dev-board ("TAPAS") works fine with ti CodeComposerStudio using the OLIMEX XDS100-V3, but Energia probably expects a V2 debug probe, so it fails when I try to flash the TAPAS dev-board with the XDS100-V3.

For anyone having a similar problem:
CONFIRM!   8)

Okay, I risked it and bought the OLIMEX XDS100-V2 and just tested it.
The USB JTAG probe uploaded the "Blink" sketch successfully! :D
From that, I assume that any Energia.nu sketch can be uploaded with that device to the TAPAS or similar boards.


(https://files.commonslab.gr/s/gdoagJP6wxzpJGT/preview)
image link (https://files.commonslab.gr/s/gdoagJP6wxzpJGT)