Hello, i asöways got an error message when i try to flash the code to the board.
What are the correz settings if the pot is detected as COM 5 on my Windows 10 System.
Waht must the string for the Serual flash settings look like.?
Marc
Hello;
Acccording to my System Device Manager, my COM Port is COM5.
I am using Windows10, and according to a hint ypo can check your port by connecting / disconnecting from USB
, while typing "ls /dev/tty*" into the Msys2 MinGW terminal:
I have noticed that my Settings for the serial flash tool port are: "/dev/tty /dev/ttyS4"
In the end i got the following error message:
"serial.serialutil.SerialException: could not open port '/??/COM5': WindowsError( 3, 'Das System kann den angegebenen Pfad nicht finden.') --> "System can't find the Path"
Any ideas why this happens and how to fix ?
Greatings Marc
This doesn't seem to be related to the hardware or the driver of ESP32-EVB.
Probably Msys2 MinGW installation or the settings are incorrect. It can also be relatated to lack of administration privileges when running CMD under Windows 10.
Try changing "/dev/tty /dev/ttyS4" to /COM5 as suggested here: https://github.com/espressif/esp-idf/issues/30
Maybe the port is busy, try changing the COM port number from Windows Device Manager.
Try running all software as administrator.
@LubOlimex
Problem solved: Iguess the promlem was not to start "as administrator".
Thanks ;-)