Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => iMX233 => Topic started by: rknollman on November 16, 2012, 06:32:32 am

Title: Copying a built Linux image to SD card
Post by: rknollman on November 16, 2012, 06:32:32 am
The OLinuXino-MAXI manual, chapter 2, section 2.7 details quite nicely how to build the Linux image from sources, including (I assume) the root filesystem and loadable modules.

The instructions in section 2.7 stop short of detailing where the output files are placed.

Please note that on my first run represented here, I FAILED to change the "MACHINE" line in fls-community-bsp/build/conf/local.conf, it still reads 'imx53qsb'.

In an attempt to find the kernel uImage and Module files, I located what appear to be these files in:
  fsl-community-bsp/build/tmp/work/imx53qsb-poky-linux-gnueabi/linux-imx-    and    /uImage......
      Are these the actual output files from the build process?

ALSO, I cannot seem to locate the output file representing the root file system that was built (I assume it would be a .tar.gz file, but I am not sure of this).


Thank you
Ron Knollman