Olimex Support Forum

ARM => ATMEL => Topic started by: ch25 on November 06, 2012, 07:38:19 pm

Title: SAM9-L9260 not run
Post by: ch25 on November 06, 2012, 07:38:19 pm
Hi I have SAM9-L9260  board  but now it does not run after power. How to check any error ?
Title: Re: SAM9-L9260 not run
Post by: LubOlimex on November 07, 2012, 03:28:04 pm
Hello ch25,

Did you connect it to a computer? Does the terminal program give any info (any error at least)? Did you provide 5V to the board?

Best regards,
Lub/OLIMEX
Title: Re: SAM9-L9260 not run
Post by: ch25 on November 07, 2012, 04:31:22 pm
I have power on 5 V  the led  5V and PWR_LED  is bright but no any action.
Title: Re: SAM9-L9260 not run
Post by: LubOlimex on November 08, 2012, 03:44:47 pm
Could you please connect a null-modem RS232 cable to the computer on 115200bps and open a terminal program on the same COM the cable is connected to? After connecting the cables This will give us some info whether it is booting, what kind of error there is, etc.

More info about the first steps can be found on the "Software development" page: https://www.olimex.com/Products/ARM/Atmel/SAM9-L9260/resources/SAM9-L9260.pdf (https://www.olimex.com/Products/ARM/Atmel/SAM9-L9260/resources/SAM9-L9260.pdf)

Regards,
Lub/OLIMEX
Title: Re: SAM9-L9260 not run
Post by: yalda on February 20, 2013, 07:08:37 am
Hi,
I want buy the SAM-L9260 board but I'm not sure that this board work with QNX operating system.
Would you guide me?
Thanks