Started by vinczo, July 07, 2017, 11:17:16 am
Quote5.1 ResetNeither RT5350F-OLinuXino, nor RT5350F-OLinuXino-EVB have hardware reset circuitimplemented. Should you need hardware reset, you can use the two pinholes named "RST_RT" onthe RT5350F-OLinuXino-EVB board (on the top side, near UART0 debug pins). "RST_RT" hastwo pinholes - the first one is routed to PORSTN (pin #15 of EXT3 connector; processor pin C10).Nearby you can also find a standalone RST pinhole exposed (only PORSTN).It is a good practice to perform software reset of the board. Performing a hardware reset or power-cycling the board (reset by disconnecting and re-applying the main power supply) might lead tosoftware corruption of the operating system.
Quoteflashrom v0.9.9-r1954 on Linux 4.4.0-83-generic (x86_64)flashrom is free software, get the source code at https://flashrom.orgCalibrating delay loop... OK.No EEPROM/flash device found.Note: flashrom can never write if the flash chip isn't found automatically.