How to connect a serial console to the GateMateA1-EVB

Started by PhilTom, April 19, 2024, 05:37:12 AM

Previous topic - Next topic


I'd like to be able to connect a serial terminal to this board so that I can run a RISC-V core and get serial data to/from it. How would I go about doing this?


There should already be debug uart pins, check GPIO12 and GPIO13 of the RPi. The DirtyJTAG software should enabled them already:

We haven't tested it, additional work might be needed on the RISC to output to those pins.
Technical support and documentation manager at Olimex