Is everyone enjoying their Agon's

Started by mrblowfelt@googlemail.com, July 27, 2023, 03:43:42 PM

Previous topic - Next topic

mrblowfelt@googlemail.com

BBC Basic and CPM what's not to love.
software is starting to make it way
across as more people get hold of
them.


TechCowboy

I'm enjoying, but I'll really enjoy it when there is some additional programming documentation.


radstar

I finally got my AgonLight2 up and running.

I've never used BBC BASIC, so I am trying to learn.

I tried loading a ".bbc" file but it reset the device.

I'll have to try it out some more.

tdg8934

It seems that I have bricked my Agon Light 2 after using the Windows ESP programing tool for the VDP. Even after closing the UART and PROG jumpers and runing the Arduino sketch for 1.04 (video.ino) - it compiles fine but nothing is displayed when moving the jumpers open again. I did have mos v2.1.0 and vdp 1.04 (trying to upgrade to 2.1.0) like the console 8. Do I need to order another Agon Light 2 (shipping is high to the USA) or can this be solved?

LubOlimex

It is hard to brick the board, probably you are perplexed or overwhelmed with info.

There is no MOS v2.1.0? Latest MOS is 1.0.4.

Refer to the recovery instructions at the end of this document:

https://github.com/OLIMEX/AgonLight2/blob/main/DOCUMENTATION/AgonLight2-user-manual.pdf
Technical support and documentation manager at Olimex

tdg8934

I was able to un-brick my Agon Light 2 by surprisingly NOT closing the 2 jumpers (UART, PROG) and runing the Arduino IDE for the video.ino sketch which I saw it write this time. The MOS is at Console8 v2.1.0 but I would like to update the VDP from 1.04 to 2.1.0. I found the firmware.bin for 2.1.0 but when I run the *flash vdp firmware.bin   it says the something about the firmware.bin is not ESP32.   How can I correct this. I tried using the Windows ESP tool for programming the 0x1000 Bootloader.bin, 0x8000 Partitions.bin and the 0x10000 firmware.bin but when I have all 3 of them checked it says there is a COM3 16 bin overlap error - which I believe is from the Partitions.bin from what I can read into.  How can this be fixed OR what do I need to do to get the VDP updated to Console8 2.1.0 ?

LubOlimex

I have no idea what is Console8 2.1.0 we recommend and load Quark VDP 1.04. Maybe try posting the same issue in the Facebook group of Agonlight project, probably more knowledgable people would have an idea what is going on. The Facebook group is here:

https://www.facebook.com/groups/agoncomputer/
Technical support and documentation manager at Olimex

markcohen

I just started using my Agonlight2 and I am not loving it. It is not able to read any SD card. I have gone over it with knowledgeable people in the Agon facebook group and they can't help me so I just put in a support ticket. Please advise how I can get this replaced. Thanks.

LubOlimex

Refer to page 7 of this document on how to prepare the card: https://github.com/OLIMEX/AgonLight2/blob/main/DOCUMENTATION/AgonLight2-user-manual.pdf

If the issue remains drop an e-mail at support@olimex.com make sure to include all details on what you have done and what is the result, maybe we can spot a problem.
Technical support and documentation manager at Olimex