MOD-IO2 not powering up

Started by agcr, February 02, 2013, 10:53:04 PM

Previous topic - Next topic

agcr

Hello everybody.

I was following the instruction manual of the MOD-IO2, but I can't get pass the powering up section.
I am using a enercell power adapter (12V @ 1A).
Is there something i'm missing? Should it be connected to the board for the LED to turn on?
Thanks for any help you can provide.

agcr

Bernd

It did just work for me. I connected a 12 V adapter and the power LED came on. Did you check the polarity of the power supply and if it is working at all?

agcr

Hello Bernd,

I just checked the power supply with a multimeter and it seems ok.

LubOlimex

Hey agcr,

Is it possible to upload the latest firmware to the MOD-IO2. You might have received a board with the older firmware (v1). The latest one is available here: https://www.olimex.com/Products/Modules/IO/MOD-IO2/resources/MOD-IO2+OLinuXino.zip.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex

agcr

Hi Lub,

Thanks for your reply.
Can you provide me with some instructions on how to do it. I checked the zip file but there were none.

Regards,
agcr