[uboot] mtest command

Started by aauer1, February 03, 2013, 04:16:03 PM

Previous topic - Next topic

aauer1

Hello,

has anybody tested the "mtest" command in uboot? I just entered the command and I get some errors. If I recompile uboot with a lower dram clock (e.g. 120MHz or 240MHz) the mtest command doesn't report the errors.

I have assembled my own board with the DDR3 RAM and A13 processor. So, I'm not sure if this is a problem of my board or it is an uboot issue. Maybe someone can test the command on a board from Olimex.

Thanks,
Andreas

JohnS

I used it and found its defaults for the memory addresses were wrong, so it tested non-existent and ROM memories!  Yes, you get errors like you did.

Worked OK when I put in all the values properly.

As I recall, the help was wrong as to how you specify the values.  I ended up reading the source code.

John