Number of SPIs and UART in A64 IND board

Started by gops, April 29, 2019, 10:29:36 AM

Previous topic - Next topic

gops

Does A64 support 2 SPIs? I could not clearly see the pinout diagram, more confusing.

Can you please point to Pinout diagram for A64 IND board? We need 2 SPI minimum.

Thank you,

Gops

LubOlimex

The A64 chip has two hardware SPIs. Just search for "SPI" in the datasheet: https://github.com/OLIMEX/OLINUXINO/blob/master/HARDWARE/A64-OLinuXino/PDF/A64_Datasheet_V1.1.pdf

One is located PC0-PC3 and the other PD0-PD3.
Technical support and documentation manager at Olimex

gops

Thanks, do you expose all the pins as shown in the Data Sheet of A64?

- Our interest in 6 UARTS + 2 SPI (  intersection between them are OK)

Is A64 40 pin GPIO is compatible with Raspberry PI Pinouts?

I found no discount for A64 IND boards if we buy bulk quantity.

Thanks

LubOlimex

QuoteThanks, do you expose all the pins as shown in the Data Sheet of A64? Our interest in 6 UARTS + 2 SPI (  intersection between them are OK)

6xUART + 2xSPI is the maximum for the chip. Some of the UARTs are data-only (RX and TX).

The interfaces are mostly available. Of course, some of the interfaces might be used by on-board peripherals.

QuoteIs A64 40 pin GPIO is compatible with Raspberry PI Pinouts?

No. The board designs are very different and such compatibility is impossible. These two designs have very different processors from different chip manufacturers.

Quotehttps://www.olimex.com/Products/OLinuXino/A64/A64-OLinuXino/open-source-hardware

Currently, all A64-OLinuXino variants are at discount. The reason is that we sell them at our lowest price possible to promote the board.
Technical support and documentation manager at Olimex