Welcome, Guest

Author Topic: Issue with A20-SOM204, no power on Port G  (Read 430 times)

Jonathan Fether

  • Newbie
  • *
  • Posts: 10
  • Karma: +1/-0
    • My Github
Issue with A20-SOM204, no power on Port G
« on: September 22, 2018, 03:14:36 AM »
I have an SOM-204EVB and am in the process of qualifying it with an alternate Bluetooth+WiFi solution (Laird Sterling-LWB based on CYW4343W (Formerly BCM4343W)).

I desoldered the Realtek device and attached jumper wires to the ports, and found poor performance of the UART port (very low signal amplitude). Also, UEXT1's UART port was not working.

After some diagnosis, I found that the root cause was that the A20's pin E18 (VCC-PG) was not receiving power. I was able to find that the regulator was disabled.

Code: [Select]
root@olimex:/sys/power/axp_pmu/regulator/regulator.7# cat name
root@olimex:/sys/power/axp_pmu/regulator/regulator.7# cat state

I was able to force the regulator online using I2C commands:

Code: [Select]
i2cset -f -y 1 0x34 0x12 0x1F
This resolved my serial port issue.

I am still trying to understand why this issue occurred. My suspicion is that Linux turns off the regulator to conserve power. I am running "ARMBIAN 5.41 user-built Debian GNU/Linux 9 (stretch) 4.17.17-sunxi".

I also noticed in the regulator section of "sun7i-a20-olimex-som204-evb.dts", that the regulator (ldo4) isn't marked always on like ldo1 and ldo2 are:

Code: [Select]
&reg_ldo1 {
regulator-min-microvolt = <1300000>;
regulator-max-microvolt = <1300000>;
regulator-name = "vdd-rtc";

&reg_ldo2 {
regulator-min-microvolt = <3000000>;
regulator-max-microvolt = <3000000>;
regulator-name = "avcc";

&reg_ldo4 {
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-name = "vcc-pg";


  • Full Member
  • ***
  • Posts: 125
  • Karma: +2/-0
Re: Issue with A20-SOM204, no power on Port G
« Reply #1 on: September 25, 2018, 06:36:34 PM »
Good catch !  ;)