STM32-E407 - there is no carrier ethernet with crossover cable

Started by anotherbrick, August 30, 2018, 06:21:51 PM

Previous topic - Next topic

anotherbrick

hello dear forum,

I am trying to ethernet connect E407 board direct to PC with crossover cable

however the activity and link status LEDs does never turn ON after reset

with standart cable - when connected via modem the LEDS are ON only after 1 minute after reset

what can I do next ?

thank you

LubOlimex

Strange behavior. Maybe related to the Ethernet cable or the power supply. How do you power the board?

This is the cable that I used to connect to a modem/router: https://i.imgur.com/KSn68wL.jpg

> with standart cable - when connected via modem the LEDS are ON only after 1 minute after reset

We tested this scenario - even if we wipe any software from the board - the LEDs work immediately.
Technical support and documentation manager at Olimex