My Olimexino 34u4 doesn't work. How can I burn the bootloader?

Started by kankoo, December 09, 2012, 11:14:31 PM

Previous topic - Next topic



I bought several olimexino 32u4 some time ago.
One of them, recording a sketch, suddenly it turned off. The board no longer works.
Is it possible that the bootloader has been erased?
How can I burn the bootloader?
Maybe is there any component burned?
Can I do some checking to the board?

Thanks for your attention.


Hey hey,

There is a decent explanation on pages 8 and 9 of the manual:

The hexes are available at 32u4's web-page:

If you want you can measure if the voltage at the tripple jumper is correct: plug in external power - the jumper for the power should be set at 5V position; then measure 3.3V and 5V (put the probe end on one and then the other end of the triple jumper, the other probe must be on a GND somewhere on the board).

Best regards,
Technical support and documentation manager at Olimex